A patchable motion instrument

Make a little movement.

Shape a wave. Patch a modulation. See the motion.

START WITH A PATCH

Motion monitor

STOPPED

100%

50%

SIMULATED OUTPUT

Ready when you are.Press Play to start the motion.

LOWER50.0%UPPER

10% lower limitCOMMAND IN RANGE90% upper limit

Simulation · no motor connected

Motion voice

YOUR BASE MOVEMENT

Rate

0.25Hz

0.022.5 Hz

Cycles per second

Stroke

70%

0100%

Total travel span

Center

50%

0100%

Position of the wave

Shape

Before motion limiting

Requested travel 56.0% · Requested rate 0.25 Hz

Modulation sources

PATCH INTO ANY DESTINATION

LFO+0.00

0.07Hz

0.01 Hz0.3 Hz

A slow, continuous wave.

Envelope0%

Attack 0.80 s

Release 1.20 s

Envelope → Stroke

Patch bay

0 / 4

Connect a source to a destination.
Depth sets how much it moves.

SOURCES

Select a source,
then a destination.

DESTINATIONS

No cables yet.Try LFO → Center for a drifting wave.

Negative depth inverts the modulation.
One cable per destination.

Travel window

Requested and planned positions stay inside this window.
Stop output before changing the limits.

Lower limit 10%

Upper limit 90%

Motor connection

Connect to your motor through a USB–RS485 adapter.

Before connecting: With power off, disconnect the 4-pin signal cable that runs to the OSSM motherboard. This setup only needs 24 V power and USB–RS485 wired directly to the motor.

Serial port

No motor connected.

Connect → Home → Arm → Run. Home measures the rail and parks at center.

Audio previewMuted

Listen to Follow Volume 20%

Pitch rises and falls with the planned position. Rate sets the pace; stroke sets how far the pitch travels.

Plays while RUN is active. Sound is a guide to the signal, not recorded motor audio.